What should I pay attention to when installing an atomizing nozzle?

What should I pay attention to when installing an atomizing nozzle?

Before"What are the characteristics of fine atomization nozzles? What are the purchasing tips?》The article lets us understand the characteristics and purchasing tips of fine atomizing nozzles. After buying it, it is installed. No matter how good the product is, but the installation method is incorrect, its characteristics will not be able to play out or even cause damage to the product. In order to enable the majority of users to get better results, the followingFine atomization nozzle factoryLet me introduce to you the precautions for installing atomizing nozzles:

1. Special elbows and tees should be used;

2. Pay attention to the system pressure test and flushing before installation;

3. If installed in a place susceptible to mechanical damage, remember to add a protective cover for the atomizing nozzle;

4. When the width of the ventilation duct is greater than 1.2m, the atomizing nozzle should be installed below the ventral surface;

5. When the nominal diameter of the atomizing nozzle is less than 10mm, a filter should be installed on the main water distribution pipe or water distribution pipe;

6. The distance between the atomizing nozzle splash plate and the ceiling, door, window, opening or wall should meet the design requirements. When the frame and splash plate of the atomizing nozzle are deformed or the original parts are damaged, they should be replaced with an atomizing nozzle of the same specification and model;

7. It is strictly prohibited to disassemble or modify the atomizing nozzle, and it is strictly prohibited to add any decorative coating to the atomizing nozzle;

8. When the atomizing nozzle is installed near a partition that does not reach the top, the horizontal distance and minimum vertical distance between the atomizing nozzle and the partition should comply with the relevant standards.

9. A special wrench should be used when installing the atomizing nozzle. It is strictly prohibited to use the frame of the atomizing nozzle to tighten;

10. When the atomizing nozzle splashing plate is higher than the bottom of a nearby beam or higher than the ventral surface of a ventilation duct with a width less than 1.2m, the maximum vertical distance between the atomizing nozzle splashing plate and the ventral surface of the ventilation duct should comply with the relevant standards;